SEH TPG60 Bedienungsanleitung PDF herunterladen (Seite 17)

Configuration

SEH TPG60/120 White Paper 17

Central print server

Creating printers and configuring V-Layer

– Create the relevant printers (printer objects) on the print server for both of the

network printers connected to the TPG60/120

. When doing so, install the

printer drivers, too. Connect both printers with a ThinPrint port. In Port Man-

ager (Illus. 26), select TCP/IP as port type (the protocol) and specify the name

convention for the printer name syntax.

– Next, rename the printers in the following format:

printer_name#ip_address:printer_id

Or:

ip_address:printer_id#printer_name

The following name convention is used below:

printer_name#ip_address:printer_id

The IP address is the .print Client Gateway’s (TPG60/120), and the printer ID

can be seen in Illus. 5. In our example, this creates the two printers connected

to the TPG60/120 (Illus. 22):

Lexmark T630#192.168.130.211:1

OKI C5510#192.168.130.211:2

Illus. 22

(The printer name before the # is unimportant for addressing print data; it only

serves to distinguish the printers.)

– Create for each of these printers a second printer, namely an Output Gateway

printer, which can be connected to any port, and share it (Illus. 23). See also

the .print Server Engine manual.

32 bit – Open the command prompt and change to the following directory on 32-bit sys-

tems:

%windir%\system32\spool\drivers\w32x86\3

x64 – ... or on x64 systems:

%windir%\system32\spool\drivers\x64\3

5 You can automate this process with .print AutoConnect (Page 23

Illus. 22 Printers and Faxes folder on the central print server

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Keine Kommentare

SEH TPG60 Bedienungsanleitung Seite 17